Handle the media messages – How to handle the [Media message]
in the tray-to-tray mode
Procedure
1.
A message on the control panel indicates that a media is missing. Select one of the following
actions as a response to the message.
• Press [Assign media].
Continue with step 2 when you select this option.
• Press [Continue].
The controller will use the PCL default media and continue the print job.
Note that this might be an incorrect media.
• Press [Cancel stream].
The print job is stopped. You can now solve the problem. It is most likely that you can solve the
problem on the host.
NOTE
Steps 2 and 3 apply only when you chose to assign a media.
2.
From the list of media, select the media that will be used as the media the controller is asking for
and press [OK].
Note that this might be an incorrect media.
The media will now be displayed with the name that is defined in the media catalog.
3.
Select the paper tray where you want to load the required media and press [OK].
4.
Load the media.
5.
Close the paper tray.
6.
Press [OK].
Now you can assign other media or continue the print job.
Handle the media messages – How to handle the [Media message] in the tray-to-tray mode
24
Chapter 2 - Transaction printing
Océ VarioPrint 6000 MICR line
Summary of Contents for Oce VarioPrint 6000 MICR Series
