Canon Oce TDS Series, Administration Manual

Page: 42 / 138

Configure Océ printer controller remote applications
Introduction and prerequisites for the configuration of the Océ
printer controller remote applications (Océ TDS/TCS systems -
except Océ TCS300)
Introduction to printer controller remote applications
The Océ TDS/TCS system can be configured locally or remotely.
• If you configure it locally, nothing needs to be installed since the controller applications (Océ
Settings Editor, System Control Panel, …) are directly accessible on the controller monitor.
• If you configure it remotely, you need to install ‘Océ Remote Logic’ or 'Océ Power Logic
Remote' on a client workstation.
NOTE
The expression 'printer controller remote applications' designates both Océ Remote Logic and
Océ Power Logic Remote.
Retrieve the Océ Remote Logic or Océ Power Logic Remote application
You can retrieve the Océ Remote Logic or Océ Power Logic Remote application via the
International Corporate Website (
"http://downloads.oce.com"
).
1. Enter the name of your printer model.
2. Click 'Show downloads'.
3. From the 'Drivers & Software' tab, select the Type 'Application Software'.
4. From the drop-down lists, select your 'Operating System' and your 'Language'.
5. Retrieve the latest version of the controller application.
Prerequisites
Before you begin the configuration procedures, make sure that you comply with the next
prerequisites list.
• Check the compatibility of the Océ Remote Logic or Océ Power Logic Remote with your Océ
TDS/TCS system and operating system.
See:
Printer controller remote applications - Compatibility matrix on page 12
• Make sure that the TCP/IP settings are correctly configured.
See:
Configure the TCP/IP settings in a network configuration by DHCP on page 26
or
Configure
the TCP/IP settings in a network configuration with a fixed IP-address on page 30
Information about the printer controller remote applications
To install Océ Remote Logic or Océ Power Logic Remote on the client workstation, and to connect
it to the Océ TDS/TCS system, please refer to the following chapters:
Configure the Océ TDS/TCS system (except TDS7x0) for use with Océ Remote Logic on page 43
or
Configure the Océ TDS7x0 system for use with Océ Power Logic Remote on page 44
.
Once the controller application is installed and connected to the Océ TDS/TCS system, you are
ready to configure your system.
Configuration of your system depends on the network environment.
Configure Océ printer controller remote applications
42 Chapter 2 - Configure the print system controller
Océ TDS/TCS/TC Connectivity information for Windows environments