Canon Oce BLM550+, Operation Manual

Page: 38 / 138

The CONFIGURE Window
Introduction
The
CONFIGURE
window lets you make changes to the configuration of the machine.
Some functions and buttons are only available at certain access levels, see 'ACCESS LEVEL'
Button overview on page 39
.
CONFIGURE Window Buttons
Button overview
Button Information Operator Supervisor
MACHINE OP‐
TIONS Touch MACHINE OPTIONS to view
the general machine setup. Some of
the settings can be changed, depend-
ing on the current access level.
Hidden Active
- MEASURE-
MENT Select 'mm' or 'inch' as the unit of
measurement. Hidden Active
- STITCH SEN-
SOR There is a sensor that checks for
stitches. Touch
STITCH SENSOR to
turn the stitch sensor on or off. The
default setting is ON.
Hidden Active
- PRESET PAPER
SIZES The preset paper sizes can be either
ISO A sizes or US paper sizes. To se-
lect which preset paper sizes are
available, touch the relevant button. Hidden Active
- PBS INSTALLED Touch
BOOK STACKER
to switch off
communication to the Book Stacker.
Only if the Book Stacker is discon-
nected.
Hidden Active
SHUTTLE
Touch
SHUTTLE
to make adjust-
ments to the tamper.
Hidden Active
-TAMPER DELAY This button is used by the service en-
gineer.
Hidden Visible
- TAMPER TIME TAMPER TIME adjusts the time that
the tamper touches the set.
An increase in
TAMPER TIME causes
a decrease in the production rate for
thin books.
Hidden Active
FORM SETUP This button is used by the service en-
gineer. Visible Visible
The CONFIGURE Window
38 Chapter 4 - The User Interface