96
Adjusting the Cut Depth
If the cutter blade is becoming less sharp or half cutting is too deep, adjust the depth of the cut.
Adjustment can be set for both "Half cut" and "Full cut."
■
Changing the Cut Depth for Half Cut
The cut depth for half cut can be set for each print media. The default setting is set to "Normal."
NOTE
• If cutting is diffi
cult depending on the material of the print media, adjust the motion of the cut.
[Example] The half cut of the label tape is too deep (or too shallow), so adjust the half-cut
depth.
1
Press the [Adjust] key.
2
Use [ ] or [ ] to select " Half Cut Depth," and then press the [Enter] key.
ɻɻ
$GMXVWPHQWV
H a l f C u t D e p t h
H a l f C u t M o t i o n
F u l l C u t D e p t h
3
Use [ ] or [ ] to select "Label," and press the [Enter] key.
Label
Clear Tube
WrapAround
H a l f C u t D e p t h
Normal
Normal
Normal
