Canon mg6400 series, Online Manual, Page: 148 / 318

Inserting the Memory Card
Important
When a memory card is inserted into the card slot, the Access lamp is lit. When the
Access lamp is flashing, the machine is accessing the memory card. In this case, do
not touch the area around the card slot.
Note
When Read/write attribute is set to Writable from USB PC or Writable from LAN PC ,
you cannot print image data from the memory card or save scanned data on the
memory card using the operation panel of the machine. After using the card slot as the
memory card drive of a computer, remove the memory card, select
Device user
settings in Device settings of Setup on the HOME screen, then set Read/write
attribute to Not writable from PC .
Setting Up the Card Slot as the Memory Card Drive of the Computer
When you use a computer to edit or enhance photos saved on a memory card, be sure
to print them from the computer. If you use the operation panel, the photos may not be
printed properly.
1. Prepare your memory card.
Attach a special card adapter if your memory card requires one.
Before Inserting the Memory Card
2. Turn on the power.
3. Insert only one memory card into the card slot.
The location to insert a memory card varies depending on each type of memory card.
Insert your memory card straightforward WITH THE LABELED SIDE FACING UP into
the card slot, according to the insert location in the figure below.
When the memory card is inserted properly, the Access lamp (A) will light up.
Be sure to attach the card adapter for memory card with the mark (asterisk), and then
insert it into the card slot as shown below.
Insert the following types of memory cards into the upper card slot:
Memory Stick Duo, Memory Stick PRO Duo
Memory Stick Micro (with the Duo size adapter)
148