Cleaning the Print Head
Clean the print head if lines are missing or if horizontal white streaks are present in the printed nozzle check pattern.
Cleaning unclogs the nozzles and restores the print head condition. Cleaning the print head consumes ink, so clean the
print head only when necessary.
1.
Make sure that the power is turned on.
2.
Hold down the
Stop
button until the
Alarm
lamp flashes orange twice, then release it
immediately.
The machine starts cleaning the print head.
The cleaning will be complete when the
ON
lamp lights green after flashing.
Do not perform any other operations until the machine completes the cleaning of the print head. This takes about 1 to
2 minutes.
3.
Check the print head condition.
To check the print head condition, print the nozzle check pattern.
Printing the Nozzle Check Pattern
Note
If the problem is not resolved after cleaning the print head twice, clean the print head deeply.
Cleaning the Print Head Deeply
101
Summary of Contents for MG3560
