Canon LBP6310dn, Manual

Page: 445 / 452

2
Enter "ping <the IP address of the printer>", then press the [ENTER] key on your keyboard.
Input example: "ping 192.168.0.215"
Correctly enter the IP address which is set for the printer. If the wrong IP address is entered, you cannot obtain an
appropriate check result.
3
Check the displayed result.
When "Packets: Sent = 4, Received = 4, Lost = 0 (0% loss)," is displayed
The IP address is set properly.
When "Packets: Sent = 4, Received = 0, Lost = 4 (100% loss)," is displayed
Ask your network administrator about the problem.
4
Enter "exit", and then press [ENTER] on the keyboard to exit Command Prompt.
NOTE
When using DHCP, BOOTP, or RARP
Consult your network administrator and perform either of the following settings.
Set the DNS Dynamic Update function.
" Configuring the Protocol Settings "
Configure DHCP or other settings so that the same IP address is always assigned to the printer when the printer is
started.
" Configuring the Protocol Settings "
Checking and configuring the subnet
Enter "ipconfig" as a command in Command Prompt.
The network setting information of the computer appears. Confirm that the computer and printer are on the same subnet.
Example:
Setting in a computer
Subnet mask: "255.255.255.0"
IP Address: "192.168.0.10" The IP address of the printer needs to be "192.168.0.xxx". (xxx indicates
an arbitrary number.)
Checking the Processor Version of Windows Vista, 7, or Server 2008
If you are not sure whether you are using 32-bit Windows Vista/7/Server 2008 or 64-bit Windows Vista/7/Server 2008, you
can check that using the following procedure.
1
From the [Start] menu, select [Control Panel].
2
Display [System].
㻠㻠㻡㻌㻛㻌㻠㻡㻞