8. Click [OK] button when download is completed. Reboot a device.
Please reboot a device.
CAUTION:
When the Control Panel still shows the download screen even after the host machine is restarted, the internal firmware
update has not been completed. Leave it as is for 10 minutes or more and press the Stop button.
9. Perform Version Information, and make sure that the firmware version matches the Version Information.
Upgrading via Internet
■ Overview
Select to automatically install the firmware update without using a computer.
■ Preparation
1. Check that there are no other jobs being executed.
2. In an environment where access is obtained via a proxy server, the proxy setting is made from the remote UI.
Settings/Registration > Network Settings > TCP/IP Settings > Proxy Settings > Edit... > Use Proxy(select)Select the [Use
Proxy] check box and specify the required settings.
■ Procedure
1. Press the [Menu] key, and update the firmware via the Internet in user mode.
System Management Settings > Update Firmware > Via Internet
NOTE:
• Refer to the User's Manual of the device for how to connect the device to the external network.
• This is applicable either in a wired LAN environment or a wireless LAN environment.
■ Messages
The message displayed on the device operation panel is as follows.
No.
Error message
The timing of oc-
currence
Remedy
1
Job in progress...
Wait a moment, then try again.
If there is a job being
executed:
1. Wait until the job is completed.
2. Cancel the job.
2
Cannot check the firmware version.
(Server communication error.)
Network error
1. Check whether the device can be connected to the ex-
ternal network.
2. Check whether the proxy setting has been made (in case
of access via a proxy server).
3
Cannot download the firmware.
(Error during download.)
1. Check whether the device can be connected to the ex-
ternal network.
2. Check whether the proxy setting has been made (in case
of access via a proxy server).
3. Check that the serial number of the host machine is
shown on the Main Controller PCB.
4
***DOWNLOAD MODE***
NETWORK AVAILABLE IP ADRESS
IP address of the machine
PRESS STOP KEY TO EXIT
If update (writing) of
the firmware has
ended in failure:
1. Update the firmware again using UST.
5. Troubleshooting
112
