2-1
CHAPTER
2
Specifying the Network Settings
This chapter describes the settings and procedures necessary to connect and use the machine with a TCP/IP
network.
TCP/IP Network Setup Procedures
To use a TCP/IP network, it is necessary to perform the following procedures.
IMPORTANT
•
It is recommended that the network manager perform steps 1, 2, and 3 above.
•
If you are printing using a TCP/IP network, you can use the following print protocols:
- LPD
- Raw (Windows 2000/XP/Server 2003 only)
•
If configuring the basic protocol settings for the first time, use the operation panel of this machine.
NOTE
The utility software of the NetSpot Console is not included in the User Software CD. To use the NetSpot Console,
please download it from the Canon website.
1
Network Cable Connection (See "To Use the Machine as a Network Printer (Network
Connection)," in the
Set-Up Sheet.
)
Connect the network cables in accordance with the
Set-Up Sheet
.
2
Preparation for Protocol Settings (See "Preparation for Protocol Settings," on p. 2-2.)
Specify the machine’s basic protocol settings for communication between the machine and computers
using the machine. To specify the settings, use:
•
The machine’s operation panel
•
NetSpot Device Installer (Canon utility software included in the User Software CD)
•
ARP/PING commands
3
Protocol Settings (See "Protocol Settings," on p. 2-5.)
Specify the machine’s advanced protocol settings. To specify the settings, use:
•
NetSpot Console (via a web browser) (Canon utility software)
•
A web browser (Remote UI)
4
Computer Settings for Printing (See "Setting Up a Computer for Printing," on p. 2-8.)
Specify the settings for each computer you use for printing.