Canon Laser Class 810, Basic Operation Manual

Page: 31 / 412

xxx
What Can I Do w
th Th
s Mach
ne?
Users in Canada
Pre-Installation Requirements for Canon Facsimile Equipment
A. Location
Supply a sutable table, cabnet, or desk. See p. 13-2 for the machne’s weght and dmensons.
B. Order Information
1. Provde only a sngle-lne to touch-tone or rotary telephone set termnated wth a standard
4-pn modular phone plug. (Touch-tone s recommended f avalable n your area.)
2. Order an CA11A modular jack (USOC code), whch should be nstalled by the telephone
company. If the CA11A jack s not present, nstallaton cannot occur.
3. Order a normal busness lne from your telephone company’s busness representatve. The
lne should be a regular voce grade lne or equvalent. Use one lne per machne.
DDD (DIRECT DISTANCE DIAL) LINE
-or-
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF YOU COMMUNICATE OVERSEAS
Canon recommends an ndvdual lne followng ndustry standards, e.g., the 2500 (touch tone) or 500
(rotary/pulse dal) telephones. A dedcated extenson off a PBX machne wthout “Camp On” sgnals s
also permssble wth the machne. Key telephone systems are not recommended because they send
non-standard sgnals to ndvdual telephones for rngng and specal codes, whch may cause a fax
error.
C. Power Requirements
The power outlet should be a three-prong grounded receptacle (Sngle or Duplex). It should
be ndependent from copers, heaters, ar condtoners or any electrc equpment that s
thermostatcally controlled. The rated value s 120 volts and 15 amperes. The CA11A modular
jack should be relatvely close to the power outlet to facltate nstallaton.