Canon iR3245, Network Manual

Page: 75 / 288

3
Using
a
TCP/IP
Network
Settings Common to TCP/IPv4 and TCP/IPv6 3-23
Settings Common to TCP/IPv4 and TCP/IPv6
This section describes the procedure for specifying the settings common to TCP/IPv4 and TCP/IPv6
using the control panel.
Specify the settings required for your network environment. If you want to use both TCP/IPv4
communications and TCP/IPv6 communications, specify the settings required for both protocols.
After performing this procedure, follow the procedure in "Confirming TCP/IPv4 Settings(p.3-33)" and
"Confirming TCP/IPv6 Settings(p.3-35)" to check whether the network settings are correct.
1. On the TCP/IP Settings screen, press [LPD Print Settings]
→
specify the
following.
Specify the LPD print settings if you are using the iR3245N/iR3235N/iR3225N, or the
iR3245/iR3235/iR3225 with the optional UFR II Printer Kit, the optional UFR II/PCL Printer
Kit, the optional PS Printer Kit, or the optional Super G3 FAX Board.
[On]: You can use LPD as the print application.
You can only output a banner page if you are using the iR3245N/iR3235N/iR3225N, or the iR3245/iR3235/
iR3225 with the optional UFR II/PCL Printer Kit or the optional PS Printer Kit.
Output of a banner page is set on a print-job basis. Even if [On] is selected for <LPD Banner Page>, a
banner page cannot be output for a print job unless it is set.
Acesst 1.0 6251194