Canon iR2318 series, Service Manual, Page: 85 / 308

Chapter 2
2-31
F-2-76
3) Remove the jump board [2].
- Screw [1], 1pc.
F-2-77
4) Remove the stay [2].
- Screws [1], 2pcs.
F-2-78
2.5.5 Installing the Reader Heater
0020-4270
1) Pull the front side [1] of the drive belt in the direction of the arrow to move
the contact sensor [2] to the vicinity of center.
F-2-79
2) Install the heater base [2].
- Screw [1], 1 pc.
3) Install the reader heater [3] on the header base [2].
- Screw [4], 1 pc.
4) Install the wire saddle [6] and route the cable [7].
5) Connect the connector [5] of the heater.
F-2-80
Mount the stream reading glass with the notch [1] of the sheet material
affixed to the glass is at the front left.
[1]
[2]
[1]
[2]
[1]
MEMO:
Though this process mentions the illustration of the model with the
document size sensor, a process is the same even with the model without the
document size sensor.
Do not touch the top surface of the contact sensor.
[1]
[2]
[1] [5] [6] [7] [4]
[3] [2]