Canon iR2318 series, Service Manual, Page: 68 / 308

Chapter 2
2-14
5) While holding the protective cover, insert the new drum unit [1] into the
main body.
F-2-20
6) Turn the developer pressure release lever [1] counterclockwise, and then
close the left door [2].
F-2-21
7) Enter the date in the drum counter label [1].
F-2-22
8) Affix the drum counter label [1] on the drum unit.
F-2-23
9) Close the front cover [1].
F-2-24
2.2.3 Installing the Toner Bottle
0020-4256
1) Shake the toner bottle 5-6 times.
F-2-25
2) Open the front cover [1].
F-2-26
3) Insert the toner bottle.
F-2-27
MEMO:
The protective cover will not be reused.
[1]
[1]
[2]
[1]
[1]
If the machine is installed in a low-temperature, low-humidity place, the
image density may be slightly lower than usual on the first approx. 100
sheets printed after installation of the machine.
When installing the machine in a low-temperature, low-humidity
environment, perform the steps mentioned in
<Going through the
Developer Idling Mode> (provided after step 6 in this section) before
installing the toner bottle.
[1]
[1]