Canon iR2318 series, Service Manual, Page: 202 / 308

Chapter 8
8-6
9) Remove the heater harness cover [2]. Disconnect the connector [3].
- Screw [1] 1 pc.
F-8-10
10) Disconnect the two connectors [1], and then release the fixing unit har-
ness from the wire saddles [2].
F-8-11
11) Raise the delivery upper guide [1]. Remove the fixing unit [3].
- Screw [2] 3 pcs.
F-8-12
8.3.2 Pressure Roller
8.3.2.1 Removing the Pressure Roller
0020-4447
1) Remove the fixing unit.
2) Remove the fixing film unit.
3) Raise the claw [1] of the fixing unit inlet guide, and remove the slide the
fixing unit inlet guide [2] by sliding it in the direction of the arrow.
F-8-13
4) Remove the pressure roller [3].
- E-ring [1] 1 pc.
- Gear [2] 1 pc.
F-8-14
[3]
[2]
[1]
[2]
[1]
[2] [3] [2]
[1]
When installing the pressure roller, bring the ground plate [4] into contact
with the roller shaft [5].
[1]
[2]
[1]
[3] [2]
[1]
[3] [2]