1
2
3
4
5
7
8
9
6
8-12
No automatic switching between telephone and fax calls.
Q
Is the machine set to switch automatically
between telephone and fax calls?
A
For the machine to switch between fax and
telephone calls automatically, the receive mode
must be set to <FaxTel>, <AnsMode>, or <DRPD>.
If you have set <AnsMode>, confirm that an
answering machine is connected to the machine
and that it is turned on with an outgoing message
properly recorded. (See “Setting Receive Mode,”
on p. 1-11.)
Q
Are documents stored in memory, leaving little
or no memory available?
A
Print, send, or delete any documents stored in
memory.
Q
Has an error occurred during reception?
A
Check the LCD for an error message. (See
Chapter 13, “Troubleshooting,” in the Basic
Operation Guide.)
A
Print an Activity Report and check for an error.
(See “ACTIVITY REPORT,” on p. 7-6.)
Q
Is paper loaded in the machine?
A
Make sure paper is loaded in the machine. (See
“Set Up the Machine,” in the Quick Start Guide.)
Q
Can the sender’s machine send the CNG signal,
which tells your machine that the incoming call
is a fax call?
A
Some machines cannot send this signal. In such
cases, receive the fax manually.