1
2
3
4
5
7
8
9
6
8-10
The documents you sent are too light.
Q
Is the density set to the <–LT> side?
A
Set the density to the <DK+> side.
Q
Are the scanning components of the machine
clean?
A
Make sure the scanning components are clean.
Sending of documents is too slow.
Q
Is the resolution set to <FINE>, <SUPER FINE>,
or <ULTRA FINE>?
A
Setting the resolution to <STANDARD> reduces
the sending time.
Q
Is Error Correction Mode (ECM) set to <ON>?
A
Because ECM corrects errors during a
transmission, any problems on the line can mean
that the transmission will take extra time. Set ECM
to <OFF>.
Cannot send using Error Correction Mode (ECM).
Q
Does the recipient’s machine support ECM?
A
If the recipient’s machine does not support ECM,
the document is sent in normal mode without error
checking.
Errors occur frequently while sending.
Q
Are the telephone lines in poor condition, or do
you have a bad connection?
A
Check if there is a device nearby that interferes
with signal transmission (e.g., microwave oven).
A
Lower the transmission speed. (See Chapter 14,
“Machine Settings,” in the Basic Operation Guide.)