Canon iR C3200 Series, Service Manual

Page: 993 / 1216

Chapter 17
17-13
E5F1 There is a fault in paper folding for the saddle.
0001 The paper fold motor (M2S) or
the paper fold motor clock sensor
(PI4S) is faulty.
The number of detection pluses of
the paper fold motor clock sensor
falls below a specific value.
0002 The paper fold motor (M2S) or
the paper fold motor clock sensor
(PI4S) is faulty.
The state of the paper fold home
position sensor remains unchanged
when the paper fold motor has been
driven for 3 sec.
E5F2 There is a fault in the saddle guide.
0001 The guide motor (M2S) or the
guide home position sensor
(PI13S) is faulty.
The guide home position sensor
does notgo ON when the guide
motor has been rotated for 0.455
sec.
0002 The guide motor (M3S) or the
guide home position sensor
(PI13S) is faulty.
The guide home position sensor
does not go OFF when the guide
motor has been driven for 1 sec.
E5F3 There is a fault in saddle alignment.
0001 The alignment motor (M5S) or
the aligning plate home position
sensor (PI5S) is faulty.
The aligning plate home position
sensor does not go ON when the
alignment motor has been driven
for 0.5 sec. (initially, driven for
1.67 sec)
0002 The alignment motor (M5S) or
the aligning plate home position
sensor (PI5S) is faulty.
The alignment plate home position
sensor does not go OFF when the
alignment motor has been driven
for 1 sec.
E5F4 There is a fault in stapling at the saddle rear.
0001 The stapler motor (rear, M6S) or
the stacking home position
sensor (rear, MS5S) is faulty.
The stitching home position sensor
does not go OFF when the stitch
motor (rear) has been rotated
clockwise for 0.5 sec.
0002 The stitch motor (rear, M67S) or
the stitching home position
sensor (rear, MS5S) is faulty.
The stitching home position sensor
does not go ON when the stitch
motor (rear) has been rotated in
reverse for 0.5 sec or more.
E5F5 There is a fault in stapling at the saddle front.
0001 The stitch motor (front, M7S) or
the stitching home position
sensor (front, MS7S) is faulty.
The stitching home position sensor
does not go OFF when the stitch
motor (front) has been driven
clockwise for 0.5 sec or more.
Code Detail Description Timing of detection