Canon iR C3200 Series, Service Manual, Page: 210 / 1216

Chapter 5
5-36
F-5-57
5.7.8.4 When Replacing the
HDD
0000-4360
If NetSpot Accountant (NSA) Is Not Used
1) Formatting the HDD
While holding down the 2 and 8 keys on the control
panel, turn on the power to start up. Using the HD
formatting function of the SST, format all
partitions.
2) Downloading the Software
Using the SST, download the various software
(system, language, RUI). The machine will take
about 10 min to start up after downloading.
If NetSpot Accountant (NSA) Is Used Together
with a Card Reader
The card ID used by the NSA resides on the HDD. If
you have replaced the HDD, therefore, you will have
to newly download the card data from NSA to enable
the statistical operations of NSA. After going through
steps 1) and 2) above, perform the following:
1) Set the following in service mode:
Make the following selections:
COPIER>FUNCTION>INSTALL>CARD; then,
enter the number of the first card, and press [OK].
(For instance, if cards No. 1 through No. 1000 are
used for group control, enter '1')
2) Turn off and then on the machine; when the
machine has started up, perform the following in
user mode:
Make the following selections: user mode>system
control settings>group ID control>count control;
then, check to see that IDs from 00000001 through
00001000 have been prepared.
Make the following selections: user mode>system
control settings>network settings>TCP/IP
settings>IP address; then, set up 'IP address'
'gateway address' and 'subnet mask'
Make the following selections: user mode>system
administrator setup; then, fill in 'system control
group ID' and 'system control ID No.' thereafter,
turn off and then on the machine.
If you leave out 'system control group ID' and
'system control ID No.' the service engineer will not
be able to 'register card to device' as part of setup
work for NSA.
3) With the machine in standby state, download the
card ID to be used from NSA.
4) When the card data has been downloaded from
NSA, check to see that the ID data has correctly
been downloaded on the screen brought up by
making the following selections:
user mode>system control settings>group ID control
(Only the downloaded ID data must be indicated.)
5) Make copies using a user card registered with NSA,
and check to see that statistical operations are made
for the device in question.