Canon iR C1020 Series, Service Manual

Page: 69 / 408

Chapter 2
2-9
F-2-23
5) Install the panel mount cover [1] removed in step 3.
- 1 claw [2]
- 1 screw [3] (The screw removed in step 3 is used.)
F-2-24
2.5.5 Card ID Registration
0019-8712
1) Connect the power plug to the power outlet and turn on the main power
switch.
2) Specify the first number of the card ID to register.
- COPIER > OPTION > ACC > CARD
- The serial numbers beginning the specified one are automatically
registered in Dept. ID for 1000 cards.
- Exit service mode after registration.
3) Select the following; [Additional Func.] > [System Management Set.] >
[Dept. ID Management] > ON, and press the OK key.
4) Press 'Back' key or 'Done' key to display the [Dept. ID and Password]
screen.
5) Select [Dept. ID:], press the OK key, enter the numeric characters regis-
tered in step 2, and then press the OK key.
6) Press [ID] key when [Dept.IDxxxx] is displayed.
- When the registration is complete, the display automatically returns to
the main screen.
7) Turn off and then on the main power switch.
8) Check to see that 'Set the control card' is displayed.
Be sure to route the card reader cable [1] through the cut-off [2] of the panel
mount cover to prevent the cable from being caught.
[1]
[1]
[1]
[2]
[1]
[2]
[3]
Be sure to enter the card number to use in service mode of the host machine
after installing the Card Reader. If the number is not entered, the card is not
recognized when being inserted.
MEMO:
Implement the procedure below to check the registration although card ID
registration is complete by performing step 1 to 3.