Settings Menu
1-17
Using t
he Ma
ch
ine
a
s
a Pr
int
e
r
1
NOTE
•
Rotate modes are not available if the machine is equipped with the optional
Finisher-U2.
•
To use the Staple or Offset mode, the optional Finisher-U2 must be attached.
•
Group and Collate are available for selection if the paper size is
A4, A4R, B5, B5R, LTR, or LTRR.
•
If Group or Collate is selected, part of the print image may be cut
off when the image is rotated. You need to load the same size paper as the original
in the paper drawers in both landscape and portrait positions. If you do not, all the
sheets will be printed in the orientation that the loaded paper is in.
•
Group and Collate are available for the following paper sizes:
A4, A4R, A3, B4, B5, LTR, LTRR, LGL, or 11"
×
17".
•
When you are stapling paper in landscape orientation, the image orientation and
the staple position may not match.
•
The Staple mode is available for selection if the paper size is A4, A4R, A3, B4, B5,
LTR, LTRR, LGL, or 11"
×
17".
•
The maximum number of sheets that can be stapled is 30 for A4R, A3, B4, LTRR,
LGL, and 11"
×
17", and 50 for A4, B5, and LTR. If the number of sheets is greater
than the limit, they will not be stapled.
Error Time Out
Off,
On
(1 to 300 sec);
15 Sec
The Error Time Out setting enables the machine to discard a print job that
remains in the machine’s memory after a specified period of time.
This setting is useful when the data for the current job has some error and
prevents the machine from performing further printing. In this case, the machine
will not receive other print commands because it performs printing in the
chronological order; the first job received is printed first, then the second job
received printed next, etc.
If the Error Time Out setting is enabled, the current job will be discarded
automatically in the specified period of time. For example, if <Error Time Out> is
set to ‘On’ and ‘20 sec’, the data for the current job will be erased from the
machine’s memory 20 seconds after the machine starts processing the data.
If <Error Time Out> is set to ‘Off’, the machine will not discard jobs automatically.
IMPORTANT
•
If a job that consists of a large amount of data is sent from a computer, the function
may cause the machine to end a print job before the complete data is received. In
this case, set a longer error time out period (in seconds).
•
If <Off> is selected, you will not be able to make copies until print jobs that use the
Staple mode are complete.
