Canon iPR C7010VP Series, Installation Manual

Page: 111 / 157

Chapter 2
2-66
2.1.9 Fixing Unit
2.1.9.1 Fixing Upper Cover / Fixing Web Unit (9 million
prints)
0026-4608 imagePRESS C6010 / imagePRESS C7010VP / imag ePRESS C6010VP /
imagePRESS C7010VP FS / imageP RESS C7010VP PSU / imagePRESS
C6010VP FS / imagePRESS C6010VP PSU / imagePRESS C6010 FS / im-
agePRESS C6010 PSU
1. Parts to replace
- Fixing upper cover (FM3-2104)
- Fixing web unit (FM3-2092)
2. Before the replacement
1) Open the sub station front right cover [1].
F-2-294
2) Release the release lever [1] in the direction of the arrow and pull out the
secondary fixing assembly [2].
F-2-295
3) Release the 2 L eaf Springs [1] and pull the Secondary Fixing Assembly
[2] until it stops.
F-2-296
3. Replacement procedure
1) Remove the 2 screws [1], and detach the primary fixing upper front cover
[2].
F-2-297
CAUTION:
When replacing, be sure to apply grease around the inner diameter of the
bearing.
(Super lube grease)
NOTE:
The following explains the procedure to remove the Fixing Upper Cover
and the Fixing Web Unit by using the Primary Fixing Assembly as an
example.
Point to Note When Working with the Fixing Assembly
Be sure to cool down the fixing assembly before starting the work.
[1]
[2]
[1]
CAUTION:
When removing the Fixing Upper Front Cover, be sure to check the
position of the Sensor Flag [1].
If the Sensor Flag is at the position [2], the Fixing Assembly cannot be
disassembled/ assembled because the Fixing Assembly is under pressure.
Follow the following steps to release the pressure of the Fixing Assembly.
1) Install the Fixing Upper Front Cover.
2) Put the Fixing Assembly in the host machine.
3) Close the Sub Station Right Front Cover.
4) Close the Sub Station Left Front Cover.
5) Turn OFF and then ON the power.
[2]
[1]
[2]
[1]