Canon IPF850, User Manual

Page: 361 / 694

Note
•
Automatic and Eject are valid only when you have selected Automatic Cutting > Yes in the printer driver.
•
With Eject, printing does not resume after a series of jobs have been printed continuously until the roll is cut.
•
Eject is the preset selection in Cutting Mode for some types of paper. For this paper, we recommend keeping the
preset cutting mode.
•
If documents printed using Automatic, Eject, or manual cutting are short, rolls are advanced a specific amount be-
fore cutting to prevent problems with cutting and paper ejection. This may create a wider bottom margin, in some
cases.
Cut rolls manually in the following cases:
Eject (when the paper surface is being scratched / to wait for ink to dry)
Select Eject
Print
Stopped automatically
at the cut position
As you support the
document to prevent it from
dropping, cut by pressing
the Cut button
Eject
Rose Wine
Important
•
When cutting wide printed documents after ejection, have two people support the documents. If the paper drops,
printed documents may be damaged.
•
Do not lift the paper when holding printed documents before cutting. If the paper rises, it may affect the printing
quality or cause rough cut edges.
Note
•
Once the following step has been performed, the procedure can be started from step 7 the next time.
•
Printing the second and subsequent times
•
Printing after replacing with the same type of paper
1
On the Tab Selection screen of the Control Panel, press
◀
or
▶
to
select the Paper tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button. The Paper Menu is displayed.
3
Press ▲ or ▼ to select Paper Details , and then press the OK button.
4
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5
Press ▲ or ▼ to select Cutting Mode , and then press the OK button.
6
Press ▲ or ▼ to select Eject , and then press the OK button.
iPF850 Specifying the Cutting Method for Rolls
User's Guide
Handling and Use of Paper
Handling rolls
361