Canon iPF825, Service Manual

Page: 33 / 316

Chapter 1
1-19
1.5.4 Carriage
0020-5456
F-1-18
[1] Printhead fixer cover
Clamps the printhead.
[2] Printhead
A principal part that houses nozzles.
[3] Printhead fixer lever
Locks the printhead fixer cover.
[4] Shaft cleaner
Keeps the carriage shaft clean.
[5] Slant adjustment lever
Makes fine-adjustments with the misregistration of ruled lines printed.
1.5.5 Ink Tank Cover (Inside)
0020-5457
F-1-19
[1] Ink tank
Ink-specific cartridge.
[2] Ink tank lock lever
Locks and thus protects the ink tank. Move this lever up and down to replace the ink tank. To open, raise the stopper of the lever until it won't go
farther and then push it to the front. To close, depress the stopper until it clicks.
[3] Ink lamp (red)
Indicates the status of the ink tank when the ink tank cover is opened, as follows:
- On
An ink tank is properly loaded.
- Off
No ink tank is loaded, or the remaining ink sensor is disabled.
- Slow blinking
Low on the inks.
- Fast blinking
Inks are out.
[4] Ink color label
Load an ink tank to meet the color and name of the label.
[5] Ink set
Ink tanks that can be used with this printer are labeled [A] on their side, which is printed in a white letter enclosed in a black circle.
[3]
[2]
[1]
[4]
[5]
A
A
MBK
BK
M
C
Y
[3]
[2]
[1]
[4]
[5]