Canon iPF5000 - imagePROGRAF Color Inkjet Printer, Service Manual

Page: 300 / 390

Chapter 6
6-4
Select [SERVICE MODE]>[I/O DISPLAY] to check the media sensor for normal operation. If the operation is abnormal, replace the media sensor.
3. Cable continuity check
If continuity of the cable between the media sensor and the main controller PCB is abnormal, replace the cable.
4. Replace the main controller PCB.
6.1.3.7 03030000-2E21 IEEE1394 error
0012-6654
iPF5000
<Cause>
The IEEE1394 interface is faulty.
<Probable fault location>
IEEE1394 interface board or main controller PCB.
<Countermeasure>
1. Turn off the printer, and then turn it on again.
2. IEEE1394 interface board
Remove the IEEE1394 interface board, nstall it again, and then turn on the printer, If the trouble persists, replace the IEEE1394 interface board.
3. Replace the main controller PCB.
6.1.3.8 03060A00-2E0E Roll media unit uninstallation
0013-2112
iPF5000
<Cause>
The auto roll feed unit cannot be detected.
<Probable fault location>
Roll feed unit PCB, connector, or main controller PCB
<Countermeasure>
1. Cable continuity check
If continuity of the cable between the roll feed unit PCB and the connector is abnormal, replace the cable.
2. Cable continuity check
If continuity of the cable between the connector and the main controller PCB is abnormal, replace the cable.
3. Replace the roll feed unit PCB.
4. Replace the connector.
5. Replace the main controller PCB.
6.1.3.9 03060A00-2E1B Roll media end error
0013-2105
iPF5000
<Cause>
During printing or roll media feed, the media sensor detected the end of the roll media.
<Probable fault location>
Roll media, roll media sensor, roll feed unit PCB, or main controller PCB.
<Countermeasure>
1. Roll media
If roll media is used up, load new roll media.
2. Roll media sensor
Select [SERVICE MODE]>[I/O DISPLAY] to check for normal operation. If the operation is abnormal, replace the media sensor.
3. Cable continuity check
If continuity of the cable between the roll media sensor and the roll feed unit PCB is abnormal, replace the cable.
4. Replace the roll feed unit PCB.
5. Cable continuit check
If continuity of the cable between the roll feed unit PCB and the main controller PCB is abnormal, replace the cable.
6. Replace the main controller PCB.
6.1.3.10 03130031-291B Lift home position error
0013-3859
iPF5000
<Cause>
The Lift home position could not be detected within the specified time.
<Probable fault location>
Lift drive unit, lift cam sensor, lift motor, or main controller PCB
<Countermeasure>
1. Visual check
Remove foreign substances from the lift drive unit if any.
2. Lift cam sensor
Select [SERVICE MODE]>[I/O DISPLAY] to check for normal operation. If the operation is abnormal, replace the lift cam sensor
3. Cable continuity check
If continuity of the cable between the lift cam sensor, lift motor and main controller PCB is abnormal, replace the cable.
4. Replace the lift motor.
5. Replace the main controller PCB.