Canon imageRUNNER ADVANCE C5500 Series, Service Manual, Page: 1054 / 1331

■ P-STOP
COPIER > TEST > P-STOP
PRINTER 1 Forcible stop of paper feed
Detail To forcibly stop paper for the next job at the specified position (only once).
Leading edge of paper stops at the specified position so that the cause of a problem can be
identified.
Set 99 when checking an image on the ITB.
When the operation is stopped forcibly, jam code "AAxx" is displayed.
When a normal jam occurs at a position other than the specified position or paper is delivered
without being forcibly stopped, this setting is automatically cleared.
Use Case - When bent paper/skew/wrinkles occur
- When jam occurs frequently
- When checking an image on the ITB
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Execute a job (copy/test print).
Paper stops at the specified position.
Caution - Remove the paper being stopped with the normal jam removal procedure. After jam removal, the
job is automatically recovered.
- Display of standard jam code indicates that a jam occurs somewhere other than the specified
position. Setting of forcible stop is enabled until paper stops at the specified position.
- The setting is disabled for job where paper does not pass through the specified position.
- Unfixed toner may be adhered on paper depending on the stop position. Thus, handle it with
care.
Display/Adj/Set Range 0 to 255
0: OFF
1: Outlet of the Cassette Pickup Assembly
20: Registration Roller, 21: Registration Roller (2nd side)
30: Inlet of the Fixing Assembly, 31: Inlet of the Fixing Assembly (2nd side)
32: Outlet of the Fixing Assembly, 33: Outlet of the Fixing Assembly (2nd side)
40: Outlet of the First Delivery *1
42: Outlet of the Second Delivery *1
70: Reverse Mouth *2
71: Duplex standby position *2
99: Inlet of the Fixing Assembly (1st side, for checking image)
Any value other than those mentioned above: Not used
*1: Paper may not be stopped depending on the delivery destination setting.
*2: Paper is stopped after being reversed for a 2-sided job.
Default Value 0
COUNTER
■ TOTAL
COPIER > COUNTER > TOTAL
SERVICE1 1 Service-purposed total counter 1
Detail To count up when the printout is delivered outside the machine.
Large size: 1, Small size: 1
A blank sheet is not counted.
Adj/Set/Operate Method N/A (Display only)
Display/Adj/Set Range 0 to 99999999
SERVICE2 1 Service-purposed total counter 2
Detail To count up when the printout is delivered outside the machine.
Large size: 2, Small size: 1
A blank sheet is not counted.
Adj/Set/Operate Method N/A (Display only)
Display/Adj/Set Range 0 to 99999999
8. Service Mode
1040