Canon IMAGERUNNER ADVANCE C5051, Getting Started

Page: 231 / 252

16
Appendix
Reports
16-7
DESTINATION ID
The name of the remote party is printed.
ST . TIME (Start Time)
The date and time (in 24-hour notation) at which the document started to transmit are printed.
USAGE T
The time taken (in minutes and seconds) to send the document from start to finish is printed.
PGS .
The number of pages that were sent is printed.
RESULT
If the documents were transmitted successfully, "OK" is printed.
If a sending error occurred, "NG" (No Good) is printed.
If a sending error occurred, the error code or “STOP” is also printed next to “NG.”
Fax Multi TX Report
This report is used to check whether documents were sent successfully to the intended destinations when a sequential
broadcast transmission was performed.
If a sequential broadcast transmission is performed when Fax TX Report is set to ‘On’, a Fax Multi TX Report is printed
automatically. (See e-Manual > Settings/Registration.)
This mode is available only if the FAX Board is installed.
You can also print a Fax Multi TX Report with an image of the sent original attached to it. (See e-Manual > Settings/Registration.)
JOB NO .
The four digit number, that is automatically assigned when the document is accepted for sending, is printed.
DEPT . ID
If Department ID Management is set, the Department ID is printed.
PGS .
The number of pages that were sent is printed.
TX/RX INCOMPLETE
If a transmission is incomplete, the fax number and the name of the destination are printed. If there is no applicable destination, "_ _ _" is
printed.
TRANSACTION OK
The fax number and the name of the destination of a completed transmission are printed. If there is no applicable destination, "_ _ _" is
printed.
ERROR
If an error in transmission occurs, the fax number and the name of the destination are printed. If there is no applicable destination, "_ _ _"
is printed.
■
■
■
■
■
•
•
■
■
■
■
■
■