Canon IMAGERUNNER ADVANCE C5051, Getting Started

Page: 111 / 252

6
Using a TCP/IP Network
Protocol Settings
6-3
Protocol Settings
This section describes how to specify the protocol settings for the machine using the control panel. If you are configuring the
settings for the first time, use the control panel of the machine.
After configuring the settings, you can change the content by using software other than the control panel of the machine. For
details, see e-Manual > Settings/Registration.
When using functions to access external servers on the internet, you may not be able to access them due to the settings of firewalls, etc. In
this case, consult your network administrator.
If you are using the imagePASS or the PS-GX, see the manual provided with the imagePASS or the PS-GX.
If you are using the imagePASS or the PS-GX, some functions are not available with this machine. For details, see the manual provided with
the imagePASS or the PS-GX.
TCP/IPv4 Settings
This section describes the procedure for setting TCP/IPv4 using the control panel. After specifying the settings for TCP/IPv4,
follow the procedure in “Settings Common to TCP/IPv4 and TCP/IPv6,” on p. 6-16 to specify the required settings, and the
procedure in "Confirming TCP/IPv4 Settings," on p. 6-24 to check whether the network settings are correct. If the settings for
TCP/IPv6 are already specified and you have finished specifying the settings common to TCP/IPv4 and TCP/IPv6, only check
the network settings after completing this procedure.
If you want to use IPv6 communications at the same time, follow the procedure in "TCP/IPv6 Settings," to specify the required
settings, and the procedure in "Confirming TCP/IPv6 Settings," on p. 6-25 to confirm the settings.
1
On the TCP/IP Settings screen, press [IPv4 Settings] → [Use IPv4] .
•
•
•