Canon imageRUNNER ADVANCE C350iF, Starter Manual, Page: 11 / 96

09
Installation Location and Handling
Contact an authorized Canon dealer if
communication is unavailable.
Depending on your locale or your telephone
connection, you may be unable to perform data
communication. In this case, contact your local
authorized Canon dealer.
Avoid installing the machine at high altitudes of
about 3,000 meters above sea level, or higher.
Machines with a hard disk may not operate properly
when used at high altitudes of about 3,000 meters
above sea level, or higher.
Select a Safe Power Supply
)
Plug the machine into a 120 V AC outlet.
)
Make sure that the power supply for the machine is
safe, and has a steady voltage.
)
Do not connect other electrical equipment to
the same power outlet to which the machine is
connected.
)
Do not connect the power cord to a multiplug power
strip, as this may cause a fire or electrical shock.
)
The power cord may become damaged if it is stepped
on, affixed with staples, or if heavy objects are placed
on it. Continued use of a damaged power cord can
lead to an accident, such as a fire or electrical shock.
)
The power cord should not be taut, as this may lead
to a loose connection and cause overheating, which
could result in a fire.
)
If excessive stress is applied to the connection part of
the power cord, it may damage the power cord or the
wires inside the machine may disconnect. This could
result in a fire. Avoid the following situations:
-Connecting and disconnecting the power cord
frequently.
-Tripping over the power cord.
-The power cord is bent near the connection part,
and continuous stress is being applied to the power
outlet or the connection part.
-Applying excessive force on the power plug.
Moving the Machine
If you intend to move the machine, even to a location
on the same floor of your building, contact your local
authorized Canon dealer beforehand. Do not attempt to
move the machine yourself.
Provide Adequate Installation Space
Provide enough space on each side of the machine for
unrestricted operation.
When no optional products are attached:
4" (100)
35 3/4" (908)
20 1/8" (511)
35 5/8" (903)
(mm)
When the Staple Finisher-S1 is attached:
4" (100)
35 3/4" (908)
20 1/8" (511)
57 3/8" (1,458)
(mm)