Canon imageRUNNER ADVANCE C3500 III Series, Service Manual, Page: 539 / 1252

Jam Code
Jam Type
Type Overview of detection Check items (in arbitrary order)
DELAY A delay jam occurs when a sensor was not turned
ON although a specified period of time had passed
after the start of detection by the sensor. • Remaining paper at the upstream of the target sensor
• Soiling on the target sensor
• Displacement of the target sensor position
• Failure of the target sensor
• Soiling (grease)/deterioration/failure of a drive motor located
upstream of the target sensor
• Soiling (paper dust)/deterioration/failure of a drive roller lo-
cated upstream of the target sensor
STNRY A stationary jam occurs when a sensor was not
turned OFF although a specified period of time had
passed after the sensor was turned ON. • Remaining paper near the target sensor
• Soiling on the target sensor
• Displacement of the target sensor position
• Failure of the target sensor
• Soiling (grease)/deterioration/failure of a drive motor located
upstream of the target sensor
• Soiling (paper dust)/deterioration/failure of a drive roller lo-
cated upstream of the target sensor
DOOR OP A door open jam occurs when a sensor detected
door open during printing operation. • Door open during printing
COVER OP A door open jam occurs when a sensor detected
cover open during printing operation. • Cover open during printing
ADF OPEN A door open jam occurs when a sensor detected
ADF open during printing operation. • ADF open during printing
SEQUENCE A sequence jam occurs when there was an error in
sensor detection signal at printing operation se-
quence.
Since the jam may occur due to sporadic noise with
software of each equipment or communication line
(interruption of communication), failure of the part
is not the cause of the jam. After the jam is removed,
the machine works. • Opening/closing of the door
• Turning OFF and then ON the power
• Error near the target sensor (soiling/displacement/failure of
the sensor, error in harness/open circuit of harness, soiling
(grease)/deterioration/failure of a drive motor, or soiling (pa-
per dust)/deterioration/failure of a drive roller)
POWER ON A power-on jam occurs when a sensor detected ON
state at power-on. • Remaining paper in the machine
• Soiling on the target sensor
• Failure of the target sensor
• Foreign matter on the target sensor (paper dust, paper lint)
ERROR An error avoidance jam occurs when an error in the
machine (excluding parts failure) was detected.
Printing operation is suspended to avoid error oc-
currence by error code; therefore, parts failure is not
the cause of the jam.
After the jam is removed, the machine works.
If it is due to parts failure, an error code instead of
the error avoidance jam is displayed on UI and
printing operation is suspended. In such case, serv-
ice technician should perform remedial work for the
error code. • Opening/closing of the door after jam removal
• Turning OFF and then ON the power after jam removal
SIZE ERR A size error jam occurs when the difference be-
tween the paper length detected by the Cassette
Guide Plate/specified on the Control Panel and the
length measured by the Registration Sensor is out
of the specified range. • Difference in paper size
• Wrong paper size setting
• Error in the Document Size Sensor (soiling/displacement/
failure of the sensor)
• Error in the Paper Size Detection Unit (failure of mechanical
structure for size detection, failure of the Guide Plate, or fail-
ure of the Cassette Size Switch)
P-STOP Forcible stop of paper feed
It occurs when a sheet of paper stops at the position
specified in service mode. • Using at problem analysis.
7. Error/Jam/Alarm
517