Canon imageRUNNER ADVANCE C3325 Series, Service Manual

Page: 277 / 951

4
4
4-56
4-56
Disassembly/Assembly■>■Image■Formation■System■>■Removing■the■Developing■Unit■>■Procedure
Disassembly/Assembly■>■Image■Formation■System■>■Removing■the■Developing■Unit■>■Procedure
Removing■the■Developing■Unit
■
■
Preparation
CAUTION:
If■you■perform■work■while■in■Deep■sleep■mode■or■when■the■power■was■turned■OFF■while■
in■Deep■sleep■mode,■the■Primary■Transfer■Roller■will■not■be■disengaged.
When■removing■the■Drum■Unit■(Bk),■be■sure■to■do■so■after■returning■the■machine■to■a■
standby■state.
1)■Remove■the■Drum■Unit.(Refer■to■page■4-55)
■ ■ Procedure
1)■Remove■the■screw■[1].
•■ 1■Screw■[1]
[1]
1x
F-4-106
2)■Pull■out■the■Developing■Unit■[1]■to■the■position■in■the■figure■below,■disconnect■the■connector■
[2],■and■hook■it■on■the■groove■in■the■cover■[3].
•■ 1■Connector■[2]
1x
[1]
[2]
[2]
[3]
1x
3)■Remove■the■Developing■Unit■[1]■while■lifting■it■up.
[1]
F-4-107
F-4-108