Canon imageRUNNER ADVANCE C255 Series, Service Manual, Page: 701 / 987

FUNCTION (Operation / inspection mode)
■ INSTALL
COPIER (Service mode for copier) > FUNCTION (Operation / inspection mode) > INSTALL
STRD-POS 1 Scan position auto adj in DADF mode
Detail To adjust the DADF scanning position automatically.
Use Case At DADF installation/uninstallation
Adj/Set/Operate Method 1) Close the DADF.
2) Select the item, and then press OK key.
The operation automatically stops after the adjustment.
3) Write the value displayed by COPIER> ADJUST> ADJ-XY> STRD-POS in the service label.
Caution Write the adjusted value in the service label.
Display/Adj/Set Range At normal termination: OK, At abnormal termination: NG
Related Service Mode COPIER> ADJUST> ADJ-XY> STRD-POS
CARD 1 Card number setting
Detail To set the card number to be used for Card Reader.
A series of numbers from the entered number to the number of cards specified by CARD-RNG
can be used.
Use Case
- At installation of the Card Reader
- After replacement of the HDD
Adj/Set/Operate Method
1) Enter the number, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution The card management information (department ID and password) is initialized.
Display/Adj/Set Range 1 to 2001
Default Value 1
Related Service Mode COPIER> OPTION> FNC-SW> CARD-RNG
AINR-OFF 1 ON/OFF warm-up rotn deact:dor open/close
Detail To set whether to disable the warm-up rotation when opening and closing the door.
By selecting 1, printing can be executed without auto adjustment at warm-up rotation when
analyzing the cause of a problem.
Use Case When printing and checking without auto adjustment at warm-up rotation when analyzing the cause
of a problem
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: OFF (warm-up rotation enabled), 1: ON (warm-up rotation disabled)
Default Value 0
E-RDS 1 Set use/no use of Embedded-RDS function
Detail To set whether to use the Embedded-RDS function.
Use Case
When using Embedded-RDS
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution Be sure to use E-RDS, RGW-PORT, COM-TEST, COM-LOG and RGW-ADR as a set.
Display/Adj/Set Range 0 to 1
0: Not used, 1: Used (All the counter information is sent.)
Default Value It differs according to the location.
Related Service Mode COPIER> FUNCTION> INSTALL> RGW-PORT, COM-TEST, COM-LOG, RGW-ADR
Supplement/Memo Embedded-RDS: Function to send device information such as the device counter, failure, and
consumables to the sales company's server via SOAP protocol
8. Service Mode
690