2
2
2-173
2-173
Process/Operation > Embedded RDS > E-RDS Setup > Confirmation and preparation in advance
Process/Operation > Embedded RDS > E-RDS Setup > Confirmation and preparation in advance
Service cautions
1) After performing the following service actions, it is necessary to perform initializing E-RDS
settings (ERDS-DAT) and communication test (COM-TEST).
Failure to do so will result that the counter transmitting value to the UGW may become
unusual.
• RAM clear of MNCON PCB SRAM Board :
[SERVICE MODE] > [COPIER] > [Function] > [CLEAR] > [MN-CON]
Also, after replacing the main controller board, all settings must be reprogrammed.
2) The following settings in service mode must not be change unless there are specific
instructions to do so. Changing these values will cause error in communication with UGW.
• Set port number of UGW
[SERVICE MODE] > [COPIER] > [Function] > [INSTALL] > [RGW-PORT]
Default : 443
• URL setting of UGW
[SERVICE MODE] > [COPIER] > [Function] > [INSTALL] > [RGW-ADR]
Default : https://a01.ugwdevice.net/ugw/agentif010
E-RDS Setup
■ Confirmation and preparation in advance
To monitor a device with e-Maintenance/ imageWARE Remote, the following settings are
required.
(1) Advance confirmation
Confirm with the UGW administrator that the device to be monitored with e-Maintenance/
imageWARE Remote is registered in the UGW.
(2) Advance preparations
Interview the user's system administrator in advance to find out the following information
about the network.
Information item 1
IP address settings
• Automatic setting : DHCP, RARP, BOOTP
• Manual setting : IP address, subnet mask and gateway address to be set
Information item 2
Is there a DNS server in use?
If there is a DNS server in use, find out the following.
• Primary DNS server address
• Secondary DNS server address
Information item 3
Is there a proxy server?
If there is a proxy server in use, find out the following.
• Proxy server address
• Port No. for proxy server
Information item 4
Is proxy server authentication required?
If proxy server authentication is required, find out the following.
• User name and password required for proxy authentication
