Canon imageRUNNER ADVANCE 6075 Series, Service Manual

Page: 776 / 1406

7
7
7-91
7-91
Error Code > Alarm Code > List of Alarm Code
Error Code > Alarm Code > List of Alarm Code
Alarm Code
List of Alarm Code
Alarm
Code
Title A. movement /B. cause /C. measures
00-0246 Error code display
(4-digit)
Soft counter PCB cannot write normally
00-0247 Error code display
(4-digit)
Soft counter PCB cannot restore data
01-0001 Fails to obtain counter
information (RDS
creates)
-
01-0002 No change in device
status after specified
period of time has
passed
(RDS server creates)
-
01-0004 IP address change
notification (RDS
server creates)
-
02-0020 Dust correction (paper
front) occurrence
Movement: Execute correction process to the pixel where dust
is detected (image on paper front)
Cause: Dust is detected on the Stream Read Glass (paper
front).
Measures: Clean the Stream Read Glass (paper front), and
check if the Platen Roller 1 is soiled. If necessary,
clean it.
02-0021 Dust correction (paper
back) occurrence
Movement: Execute correction process to the pixel where
dust is detected (image on paper back with 1-Path
DADF).
Cause: Dust is detected on the Scanner Glass (paper back).
Measures: Clean and check the Scanner Glass (paper back),
and check if the Platen Roller 2 is soiled.
Alarm
Code
Title A. movement /B. cause /C. measures
04-0001 Right Deck Lifter error Movement: The Right Deck Lifter Motor (M4) is stopped. Not
using the Right Deck.
Cause: The Right Deck Lifter does not rise, failure of the Right
Deck Paper Height Sensor (PS6).
Measures:
1. Turn OFF/ON the power.
When it is recovered, the measure is completed. If it is not
recovered, execute the following measures.
2. Check if the Deck Lifter rises.
If not, execute the following measures. If an alarm occurs
although it rises, execute step 5 and later steps.
3. Check the connection between the Right Deck Lifter Motor
(M4) and the Feed Driver PCB (PCB3).
Motor side: J2069, PCB side: J225
4. Replace the Right Deck.
5. Check the connection between the Right Deck Paper Height
Sensor (PS6) and the Feed Driver PCB (PCB3).
Sensor side: J2063, J3633 (relay), PCB side: J222
6. Check the operation of the Right Deck Paper Height Sensor
(PS6), and replace it.
7. Replace the Feed Driver PCB (PCB3).
04-0002 Left Deck Lifter error Movement: The Left Deck Lifter Motor (M5) is stopped. Not
using the Left Deck.
Cause: The Left Deck Lifter does not rise, failure of the Left
Deck Paper Height Sensor (PS10).
Measures:
1. Turn OFF and then ON the power.
When it is recovered, the measure is completed. If it is not
recovered, execute the following measures.
2. Check if the Deck Lifter rises.
If not, execute the following measures. If an alarm occurs
although it rises, execute step 5 and later steps.
3. Check the connection between the Left Deck Lifter Motor
(M5) and the Feed Driver PCB (PCB3).
Motor side: J2051, PCB side: J225
4. Replace the Left Deck.
5. Check the connection between the Left Deck Paper Height
Sensor (PS10) and the Feed Driver PCB (PCB3).
Sensor side: J2045, J3634 (relay), PCB side: J221
6. Check the operation of the Left Deck Paper Height Sensor
(PS10), and replace it if necessary.
7. Replace the Feed Driver PCB (PCB3).