Canon imageRUNNER 3530, Reference Manual

Page: 192 / 460

Specifying Common Settings 4-36
4
Customizin
g Se
ttin
gs
Energy Consumption in the Sleep Mode
You can set the amount of energy that the machine consumes when it is in the
Sleep mode.
NOTE
•
If there is less than ten minutes remaining before sending a job which has been reserved
for delayed sending, the machine will not enter the Sleep mode completely.
•
In some cases, the energy consumption level in the Sleep mode is 'High' even when the
energy consumption level is set to 'Low', such as when:
- A job is being processed (including a report job or receive job).
- The optional USB Application Interface Board is installed.
- Any of the following settings are set from the Additional Functions screen:
*1 If it takes more than 10 minutes for the machine to start up after powering ON, the machine consumes the same
amount of energy as when the energy consumption level is set to 'Low'.
•
The default setting is 'Low'.
1
Press (Additional Functions)
➞
[Common Settings].
If necessary, see the screen shot in step 1 of "Initial Function at Power ON," on p.
4-17.
The Daily Activity Report Time setting for the Fax function is set to 'On'.*
1
(See Chapter 7, "Printing Communication Reports," in the Facsimile Guide .)
The time limit for receiving fax documents in memory is set.* 1
(See Chapter 6, "System Manager Settings," in the Facsimile Guide .)
The DHCP setting is set to 'On'.* 1
(See Chapter 3, "Using a TCP/IP Network," in the Network Guide .)
The NetWare setting is set to 'On'.
(See Chapter 4, "Using a NetWare Network (Windows)," in the
Network Guide .)
The AppleTalk setting is set to 'On'.
(See Chapter 6, "Using an AppleTalk Network (Macintosh)," in the
Network Guide .)
The SMB setting is set to 'On'.
(See Chapter 5, "Using a NetBIOS Network," in the
Network Guide .)