Canon imageRUNNER 2520 Series, Service Manual, Page: 219 / 402

Ecode Detail Code Item Description
E805 0002
Remedy 1.Disconnect and then connect the connector (J206) on the DC
Controller PCB (PCB4).
2.Replace the Exhaust Fan (Front) (FAN4).
3.Replace the DC Controller PCB (PCB4).
E805 0003 Title Unstable rotation of the Exhaust Fan (Front) (FAN4)
Description When lock signal failed to be detected for 5 sec while the Exhaust
Fan (Front) (FAN4) is driven. * The same condition is detected after
the error retry is performed.
Remedy 1.Disconnect and then connect the connector (J206) on the DC
Controller PCB (PCB4).
2.Replace the Exhaust Fan (Front) (FAN4).
3.Replace the DC Controller PCB (PCB4).
FAX Error Code
■ Outline
● Error Code Outline
An error code is used to indicate a fault in a machine, and is indicated in the machine's LCD or reports, showing the nature
(symptoms) of the fault. Using the errorcode, the user or the service man can readily find out how to correct the fault by simply
referring to the User's Manual or service manual.
An error code may be either of the following two types:
• User Error Codes
A fault indicated as a user error code is one that can easily be corrected by the user, as by operating the machine. It takes
the form of "# + number."
• Service Error Codes
If a fault calls for a service man for correction, it is indicated as a service man error code in the form of "## + number" or
"SYSTEM ERROR E + number."
NOTE:
• A service error code expressed in the form of "## + number" will not appear on the LCD, Error Tx Report, or Activity Report
while the machine remainsin factory default state. To check a service error code, shift bit 0 of service soft switch #1 SSSW
SW01 to '1'.
• For the causes and countermeasures of error codes, refer to the separate G3/G4 Facsimile Error Code List.
■ User Error Code
● User Error Code
No. Description
#0001 An original has jammed.
#0003 Time-out for copying or sending/receiving a single page has occurred.
#0005 Time-out for initial identification (T0/T1) has occurred.
#0009 Recording paper has jammed or is absent.
#0012 Recording paper is absent at the other party.
#0018 Auto call initiation has failed.
#0022 Documents could not be forwarded to the specified destination because there is insufficient memory available.
The machine can store up to total of 71 jobs of send and transmission report in memory.
#0037 Image memory overflow at time of reception has occurred.
#0059 The number you dial and connected number (CSI) does not match.
#0099 A job was canceled during transmission to a USB memory media device.
A secured print job was automatically canceled after the timeout period elapsed.
#0401 The USB memory media device is full or the maximum number of files that can be stored in the root directory (the top level
of the directory tree in the USB memory media device) has been reached.
7. Error/Jam/Alarm
209