Canon imageRUNNER 2320, Reference Manual, Page: 214 / 292

Routine Cleaning 6-26
Ro
ut
ine Ma
int
e
n
ance
6
Manual Feeder Cleaning
If your originals have black streaks or appear dirty after copying them using the
feeder, this may be caused by pencil writing rubbing off the originals and onto the
roller. Perform this feeder cleaning procedure to clean the feeder scanning area,
film, and roller.
WARNING
When cleaning the machine, first turn OFF the main power switch and
disconnect the power cord. Failure to observe these steps may result in a fire or
electrical shock.
CAUTION
Do not dampen the cloth too much, as excess water may break the machine.
IMPORTANT
•
If the feeder scanning area is dirty, it may result in a paper jam or smudged or dirty prints.
•
Clean the roller while spinning it with your hand.
NOTE
This procedure is necessary only if the optional feeder (DADF-P2) is attached.
1
Open the feeder cover.
2
Clean the rollers (a total of three
places) inside the feeder cover
with a cloth dampened with water.
Then wipe the area with a soft, dry
cloth.