Canon IMAGEPRESS C7010VPS, Operating Information Manual, Page: 153 / 388

Stack the prints with an offset
Introduction
The 'Offset stacking' function creates a visible distinction between sets or jobs in an
output location. The active workflow profile or the active automated workflow determines
the default type of offset stacking. The table below describes the possible types of offset
stacking. Furthermore, the table describes when you can change the defined type of offset
stacking in the 'Properties' window.
Types of offset stacking
#
Possible changes in the 'Properties' window Default type of offset
stacking
No changes possible. 'Jobs'
You can indicate the number of sets (N sets) after which
an offset will be applied, for example 5.
Then 5 sets will be delivered in a straight stack. The next
5 sets will also be delivered in a straight stack, but with a
shift compared to the previous stack.
N must be a value between 1 and 65536 (default = 1). 'Sets (always)'
NOTE
When 'Sets (always)' is possible, the 'Properties' window displays a special button at
the upper right-hand side which is otherwise not visible.
You can set the 'Offset stacking' function to:
■
'On' - each set will be shifted compared to the previous
set, or
■
'Off' - all sets are delivered in 1 straight stack.
'Sets (as in job)'
No changes possible. 'Banners'
No changes possible. 'Off'
How to change the type of offset stacking in the Properties window
1.
Touch 'Jobs' -> 'Waiting jobs'.
2.
Touch the job of which you want to change the type of offset stacking.
#
NOTE
You can only change the settings of the active print job after you stopped the
printer (press the 'Stop' button 2x).
3.
Touch 'Properties' - or touch the job 2x to open the 'Properties' window.
Chapter 6 - Print jobs 153
Stack the prints with an offset