Canon imagePRESS C1+, Reference Manual, Page: 247 / 622

Adjusting the Machine 4-77
4
Customizing S
e
ttings
Visual Correction
1
Press
➞
[Adjustment/Cleaning]
➞
[Shading Correction].
2
Press [Visual Correction].
3
Press [Test Print].
4
Press [Test Print].
Test print is output.
CAUTION
Only 330 mm x 483 mm, 320 mm x 450 mm (SRA3), 305 mm x 457 mm, 11" x 17", A3,
LTR, or A4 plain paper can be used for test prints. Make sure that a sufficient supply of
paper is loaded into the machine before starting this procedure.
5
View the output test print
➞
press [Fine Adjust] of the colour you want
to adjust.
6
Select the number to adjust
➞
press [+] for the heavy density or [-] for
the light density
➞
[OK].
NOTE
The colour patterns on the test print are laid out in numeric order (-6 to 6) when the cyan patterns
are on top. The patterns under -6 and 6 may not be shown, depending on the paper width. In this
case, the numbers are from -5 to 5.
7
Press [Store and Finish].
The display returns to the screen of step 2. Repeat these steps until the shading is improved.
NOTE
If [Test Print] is pressed before pressing [Store and Finish], a test print with colour patterns after
adjustment is output.