Canon imagePRESS A3200, Installation And Service Manual

Page: 51 / 192

U
SING THE IMAGE
PRESS S
ERVER
51
Starting, shutting down, restarting, and rebooting
The customer will generally leave the imagePRESS Server on all the time. Remember
that when the imagePRESS Server is powered off, network access to the copier is interrupted.
Power off the imagePRESS Server when you need to service the imagePRESS Server and
before you remove or attach any cables to the imagePRESS Server.
If necessary, you can also restart or reboot the imagePRESS Server. Restarting the
imagePRESS Server resets the imagePRESS Server system software without restarting the
system entirely. Rebooting the imagePRESS Server restarts the system entirely.
Always use the following procedures when starting, shutting down, restarting, or rebooting
the imagePRESS Server. Use the reset button on the front of the imagePRESS Server only if
the system is frozen and unresponsive to keyboard or mouse actions.
T
O START THE IMAGE
PRESS S
ERVER
1. Make sure that the power switch on the back of the imagePRESS Server is in ON (|) position,
and then power on the imagePRESS Server using the power button on the front panel.
For more information, see Figure 10 and Figure 11 on page 42 .
2. Wait for the system to power on and reach Idle.
The imagePRESS Server takes approximately 5 minutes to power on and reach Idle.
T
O SHUT DOWN THE IMAGE
PRESS S
ERVER FROM THE
C
ONTROL
P
ANEL
N
OTE
:
Unless instructed otherwise by a service procedure, always shut down the
imagePRESS Server from the Control Panel or the copier touch panel. Do not use the power
button on the front of the imagePRESS Server to shut down the system.
1. Ensure that the imagePRESS Server is not receiving, processing, or printing any files.
If the system has just finished processing, wait at least 5 seconds after the system reaches Idle
before beginning the shutdown procedure.
N
OTE
: Notify the network administrator before you remove the imagePRESS Server from
the network.
2. Press the Menu button on the imagePRESS Server Control Panel.
3. Press the line selection button for Shut Down System.
Allow the system to shut down completely.
4. If desired, move the power switch on the back of the imagePRESS Server to the OFF (O)
position for maximum energy savings.
5. If you are shutting down in order to service the imagePRESS Server, wait 10 seconds after
powering off, and then remove all external cables from the back of the imagePRESS Server.