![background image](http://html.mh-extra.com/html/canon/imageformula-p-215/imageformula-p-215_service-manual_62996046.webp)
3-2
COPYRIGHT © CANON ELECTRONICS INC. 2011
CANON P-215 FIRST EDITION
CHAPTER 3 DISASSEMBLY & ASSEMBLY
Notes on assembling
A figure of the gears’ assembling is shown
below.
Figure 3-103
After assembling the pickup tray unit,
place the cable (FPC, FFC) in the right
cover and install it. The mark
{
1
on the
bottom of the cover is on the eject side.
Figure 3-104
3. Left Cover
1) Remove the bottom cover.
2) Insert a tool with thin and flat tip into the
upper and lower holes
{
1
(2 holes each),
and pick the edge of the cover to remove
the fitting parts, then remove the left cover
{
2
.
Note:
Be sure to insert the tool into the correct
positions.
Since the left cover may jump out, re-
move it while holding it by hand.
The pickup tray unit and inside gears
can be removed when the left cover is
removed.
Figure 3-105