CHAPTER 3 DISASSEMBLY & REASSEMBLY
5. Upper Feed Guide Plate
Notes on assembling
1) Remove the upper cover.
All of the fitting parts should be fully
seated. There should not be any raised
parts.
2) Remove the upper reading unit.
The reading unit cable should come out
through the hole.
3) Open the front unit, unhook the 3 pairs of
fitting parts
{
1
at the bottom, and then
push the plate out slightly. Completely
open the front unit, and pull out the
bottom of the upper feed guide plate
{
2
.
Next, unhook the pair of fitting parts in
the center
{
3
and the 4 pairs of fitting
parts at the top
{
4
and remove the
upper feed guide plate. You should
completely detach the fitting parts.
If the guide plate has been deformed too
much and does not return to its original
shape and affects feeding, either repair
it or replace it with a new part.
Note:
For the fitting parts on the bottom side,
unhook the left and right fitting parts
by pushing while bending the plate
downwards, and unhook the central
fitting part by pushing while bending
upwards.
Figure 3-208
COPYRIGHT
©
CANON ELECTRONICS INC. 2011 CANON DR-M160 FIRST EDITION
3-7