Canon image RUNNER 3245, Getting Started Manual, Page: 39 / 180

Checking Your Network Environment 3-9
3
Before Connecting to a Network
Checking Your Network Environment
Refer to the following examples to confirm the network environment that is connected to the
machine, and then perform the necessary operations for that environment.
Sample Windows Network
In a Windows network environment, the TCP/IP or NetBIOS (NetBIOS over TCP/IP) protocol can be
used. Multiple protocols can be used at the same time.
In addition to IPv4 (Internet Protocol Version 4), the machine also supports IPv6 (Internet Protocol
Version 6), and has a dual stack configuration that enables it to communicate with both IPv4
networks and IPv6 networks. You can select whether to use the functions of IPv4 or IPv6. You can also
enable the functions of both IPv4 and IPv6. The IPv4 network and IPv6 network used by the machine
supports IPSec (Security Architecture for Internet Protocol). (See e-Manual > Network.)
To use the e-mail/I-fax function, the TCP/IP protocol is required.
After configuring the settings in accordance with Chapter 4, "Settings Common to the Network
Protocols," see the following, depending on the protocol:
Chapter 5, "Using a TCP/IP Network"
Chapter 7, "Using a NetBIOS Network"
Optional equipment is required to use the e-mail/I-fax functions if you are using the imageRUNNER
3245/3235/3230/3225. For the equipment needed, see “Optional Equipment and System Requirements for
Connecting to a Network,” on p. 3-2.
The machine does not support NetBEUI.
To perform IPSec communication, the optional IPSec Board must be installed after installing the optional
Expansion Bus.
•
•
•
•
•