Canon HJ40E, Operation Manual

Page: 86 / 186

E84
4. Operation in Full Mode
[ ] 1
[ ] 2
[ ] 1
[ ] 2
MENU MENU
MENU
[ I-Gain ]
[Trk]OFF
[ ]
MENU
1
A
Fr1P
[ Basic ]
IS STD IS STD
[ I-Gain ]
[Trk]OFF
A
Fr1P
[ Basic ]
IS STD IS STD
MENU MENU
MENU
[ I-Gain ]
[Trk]OFF
A
Fr1P
[ Basic ]
IS STD IS STD
4.1.3 Switching Users
[ ]
Settings for users 0–9 can be con fi gured in Full mode.
User 1–9
Con fi gure advanced settings for each user needed. Settings for the users can then be saved.
User 0
User 0 is the default user. Thus, for this user you can adjust settings temporarily but not save them.
Setting information is cleared when you switch to users 1–9 or turn the lens off. User 0 is used if you perform an
escape operation. For details, see
“ 4.1.16 Escape Operation. ” Selecting user 0 restores the default settings, except
for the auto and remote iris gain values and encoder output setting.
Switch to the desired user (0–9) from the
Top screen.
Con fi gure advanced settings for these users from the Menu screen . See “ 4.2 Con fi guration from the Menu Screen. ”
Press .
The previous or default value is highlighted.
Press .
The display starts blinking.
Press or .
Press left or right until you reach the desired value.
Press .
The display changes from blinking to highlighted, indicating
con
fi rmation.
1
2
3
4
Initial Top Screen
Options
0
(D)
1 2 3 4 5 6 7 8 9
Save Settings
Not supported
Although settings cannot be saved, they can be changed
temporarily.
Switching users or turning the lens off will restore default
values.
Can be saved for each user
(D): Default value
MENU
[ ] 1
or