Canon g3000 series, Online Manual, Page: 440 / 852

Initial Check Items (System Cleaning)
Before running System Cleaning , check that the printer power is on.
Then check the following items:
• When you ran Nozzle Check , were there areas where the print was smeared or unprinted areas?
• Did the condition not improve even after Deep Cleaning was run?
• Are the remaining ink levels insufficient?
◦ Visually check whether the remaining ink levels are insufficient.
If System Cleaning is run when the remaining ink levels are insufficient, it may trigger a failure.
◦ If you selected All Colors or Black for Ink Group , check that all remaining ink levels are at least
at the single dot position indicated on the ink tanks. (The color inks are consumed even if Black
was selected.)
If you selected
Color , check that the remaining ink levels for all color inks are at least at the single
dot position indicated on the ink tanks.
◦ If any remaining ink level is below the single dot position, replenish the ink to at least the single
dot position. However, if Remaining Ink Notification Settings is enabled, replenish all remaining
ink levels to the upper limit line indicated on the ink tanks, regardless of the Ink Group setting.
Start Print Head Alignment dialog box
This dialog box allows you to adjust the attachment position for the print head, or to print the current
setting value for the print head position.
Align Print Head
Aligns the print head.
Print head alignment corrects the installation positions of the print head and improves deviated colors
and lines.
Align the print head immediately after installing the print head.
Print Alignment Value
Click this button to check the current setting value of the print head position.
Prints the current setting value for the print head position.
Print Head Alignment dialog box
To adjust the print head position manually, click Align Print Head in the Start Print Head Alignment
dialog box, and perform the operations instructed in the messages. The Print Head Alignment dialog
box is then displayed.
This dialog box allows you to check the printed pattern and adjust the print head position.
Preview Window
Displays the pattern of Print Head Alignment , and checks the position of the selected pattern.
You can also change the setting by clicking the pattern on the screen directly.
Select the Pattern Number
Compare the printed adjustment patterns, and enter the pattern number of the pattern with the
least visible streaks or horizontal stripes into the corresponding box.
Note
• If you do not know how to analyze the printed pattern, see Aligning the Print Head Position .
440