Canon Finisher-Q1, Service Manual

Page: 41 / 64

Chapter 3
3-7
2) Remove the screw[1]and disconnect the
connector[2].
3) Remove the scrap full detector PCB [3].
F-3-23
3.3.3 Punch Controller PCB
3.3.3.1 Removing the Upper
Cover
0008-1875
1) Remove the screw [1] at the front.
F-3-24
2) Remove the two screws [1] at the back to detach the
upper cover [2].
F-3-25
3.3.3.2 Removing the Punch
Controller PCB
0008-1815
1) Remove the screw [1] to move the plate [2] to the
left.
F-3-26
2) Flip up the Mylar [1] and disconnect the seven
connectors [2].
3) Remove the two screws [3] to remove the punch
controller PCB [4].
[1]
[2]
[3]
[1]
[1]
[2]
[1]
[2]