5
5
5-100
5-100
Adjustment > Auxiliary Adjustment > Adjusting Paddle Height > Procedure
Adjustment > Auxiliary Adjustment > Adjusting Paddle Height > Procedure
Adjusting Paddle Height
This adjustment is to be executed if any of followings occurs; tray stack failure due to thin
paper, staple alignment failure.
■
Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
F-5-235
■
Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
SW382
SW381
SW383
(-)
(+)
ENTER
SW384 SW385
DSP381
[1]
2) Press SW385 [1] so that the height adjustment for the paddle is ready now.
SW382
SW381
SW383
(-)
(+)
ENTER
SW384 SW385
DSP381
[1]
F-5-236
F-5-237
Summary of Contents for Finisher-AK1
