1
2
3
4
5
1-7
5.
Press [Stop/Reset] to return to standby mode.
FAX/TEL: Optional Settings
If required, change the optional settings as follows:
<SET RING START TIME>: Use the numeric buttons to enter
the duration (0 to 30 seconds) for which the machine listens for
the fax tone before it starts ringing. Press [Set].
<SET F/T RING TIME>: Use the numeric buttons to enter the
duration (10 to 45 seconds) of ringing. Press [Set].
<SET DEFAULT ACTION>: Use [Left/Right] to select the default
action the machine will take after the ringing ends, then press
[Set].
– <RECEIVE>: Tries to receive the document.
– <DISCONNECT>: Disconnects the call.
AnsMode: Optional Settings
If required, change the optional settings as follows:
<SET CHECK TAD TIME>: Use the numeric buttons to enter the
duration (10 to 30 seconds) for which the machine waits until the
connected answering machine takes the call. Press [Set].
<SET FAX DETECT TIME>: Use the numeric buttons to enter
the duration (10 to 70 seconds) for which the machine attempts
to detect the fax tone. Press [Set].
■
Memory Reception
The machine automatically receives faxes in memory when
printing is disabled under certain conditions (i.e., toner or paper
has run out). You can also set the machine to receive faxes in
memory during a certain time period of your choice, with
password protection if required.
1.
Press [Menu].
2.
Use [Up/Down] to select <RX SETTING?>, then
press [Set].
3.
Use [Up/Down] to select <1 MEMORY RX
MODE?>, then press [Set].
4.
Use [Left/Right] to select <ON>, then press
[Set].
