41
Preparing the Camera
Using the Optional EVF-V70 OLED Electronic Viewfinder
After attaching the supplied clamp base to the camera, you can attach the optional EVF-V70 OLED Electronic
Viewfinder to the clamp base. An optional UN-5 or UN-10 Unit Cable is required to connect the optional
viewfinder to the camera. You can adjust the viewfinder’s swing arm and clamp rail sliders to set the viewfinder
to a comfortable viewing angle. To protect the viewfinder’s OLED panel, the viewfinder will be dimmed
automatically when it is not in use.
Throughout the manual, the EVF-V70 will be referred to simply as “the optional viewfinder”.
Attaching the Optional Viewfinder
1
Press the
Q
button to turn off the camera.
2
On the optional viewfinder, loosen the swing arm’s locking
screw (clamp rail side).
3
Remove the clamp rail’s end cap.
4
Insert the swing arm’s slider into the clamp rail with the “TOP”
label facing up.
5
Attach the end cap to the clamp rail.
6
Attach the supplied clamp base to the desired position on top
of the camera and loosen the clamp rail locking screw.
• Use the supplied hex wrench to secure it firmly with the 4 hex
socket head bolts.
7
Remove the end cap from the other arm of the
clamp rail and insert the slider at the front of the
clamp base into the clamp rail.
8
Attach the end cap to the clamp rail.
9
Loosen the other swing arm’s locking screw
(viewfinder side).
10 Adjust the optional viewfinder to the desired position
(up/down, front/back) and fasten all the screws.
• Be sure to firmly hold the viewfinder with one hand as
you adjust its position.
• Fasten the two locking screws of the swing arm and the
clamp rail locking screw on the clamp base.
햴
햵
햶
햳
햷
햷
햸
,
햹
햺
햻
햻