Canon EOS 7D Mark II (G), Instruction Manual, Page: 456 / 550

8
3: Custom Controls
N
456
In manual exposure <
a
>, you can set the aperture with the <
5
> or
<
6
> dial.
Pressing the button assigned to this function will switch to the image-
recording quality set here. While this change is in effect, the image-
recording quality (JPEG/RAW) will blink in the viewfinder (with [
Show/
hide in viewfinder ]’s [ Image quality ] checkmarked). After the shooting
ends, the One-touch image quality setting will be canceled and the
image-recording quality will be switched back to the previous quality.
*6:On the setting screen, by pressing the <
B
> button, you can select the image-
recording quality for this function.
Pressing the button assigned to this function will switch to the image-recording
quality set here. While this change is in effect, the image-recording quality
(JPEG/RAW) will blink in the viewfinder (with [
Show/hide in viewfinder ]’s
[ Image quality ] checkmarked). Even after shooting, the One-touch image
quality setting will not be canceled. To revert to the previous image-recording
quality setting, press the button assigned to this function again.
*6:On the setting screen, by pressing the <
B
> button, you can select the image-
recording quality for this function.
Press <
0
> to display the image-recording quality setting screen
(p.149) on the LCD monitor.
: Aperture setting in M mode
: One-touch image quality setting
: One-touch image quality (hold)
: Image quality
If RAW or RAW+JPEG is set for the image-recording quality to be switched
to with [
One-touch image quality setting ] and [ One-touch image quality
(hold) ], [ Multi Shot Noise Reduction ] (p.176) will not work after the switch.
For [
z
3: High ISO speed noise reduct’n ], [ Standard ] will be applied for
shooting.
During the switch to the One-touch image quality setting, you can display
<
z
> in the viewfinder and on the LCD panel (p.441).