![background image](http://html.mh-extra.com/html/canon/dr-x10c-imageformula-document-scanner/dr-x10c-imageformula-document-scanner_service-manual_62895102.webp)
3-32
COPYRIGHT © CANON ELECTRONICS INC. 2008
CANON DR-X10C FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
V. BASE UNIT-3 (READING SYSTEM)
Note:
If the reading unit is disassembled fur-
ther, be careful to prevent entry of dust.
Do not touch the inner surfaces of glass
and the surfaces of the lens array with
fingers. If they are dirty, clean them with
a clean dry cloth.
If the inside is not disassembled, re-
place the entire reading unit.
Note:
The differences between the parts of the
reading unit (upper) and the reading unit
(lower) are the cable cover and flat ca-
ble. The wiring of some cables and the
direction of assembly are different.
1. Reading Unit (Lower)
1) Remove the left cover.
2) Remove the platen roller (lower).
3) Unhook 2 pairs of the fitting parts
{
1
and
remove the gear
{
2
and pin
{
3
for the
reading roller (middle).
Note:
Do not drop and lose the pin.
Figure 3-501
4) Remove the stop ring
{
1
and while re-
moving the ball bearings
{
2
on both sides,
remove the reading roller (middle)
{
3
.
Figure 3-502
5) Remove the screw
{
1
(M3, round tip) and
remove the support plate
{
2
. In the same
way, remove the support plate on the
opposite side.
Figure 3-503